Refrigerator Use; Ensuring Proper Air Circulation; Using The Control; Refrigerator Features - Whirlpool EL1WSRXLQ0 Use & Care Manual

REFRIGERATOR USE

Ensuring Proper Air Circulation

In order to ensure proper temperature, you need to permit proper
airflow in the refrigerator. Do not cover the shelves with towels or
plastic. If the shelves are covered, temperature and moisture
problems may occur.
IMPORTANT: To prevent odors and keep food from drying out,
wrap or cover foods tightly.

Using the Control

Setting the refrigerator control
The refrigerator control is located on the outside of the
refrigerator at the top. For your convenience, your refrigerator
control is preset at the factory. When you first install your
refrigerator, make sure that the control is still preset to the mid-
setting as shown.
NOTE: To turn your refrigerator off, turn the refrigerator control to
OFF. Your product will not cool when the refrigerator control is set
to the off position.
6
Adjusting the refrigerator control
Give the refrigerator time to cool down completely before adding
food. It is best to wait 24 hours before putting food into the
refrigerator. The control is set correctly when milk or juice is as
cold as you like. Move the dial one setting at a time and wait 24
hours between adjustments.
IMPORTANT: If you add food before the refrigerator has cooled
completely, your food may spoil. Turning the control to a colder
(higher) than recommended setting will not cool the compartment
any faster.
Additional refrigerator control
Your refrigerator has an additional refrigerator control located on
the inside on the convertible compartment. This additional
control is for use if the room air temperature falls to 48°F (16°C).
To keep the refrigerator compartment from becoming too cold,
slide the additional refrigerator control to COLD.
When the room air temperature is above 48°F (16°C), slide the
additional refrigeration control to COLDER for best results.
REFRIGERATOR
FEATURES

Refrigerator Shelves

Store similar foods together and adjust the shelves to fit different
heights. This reduces the time the refrigerator door is open and
saves energy.
To remove and replace a shelf:
1. Remove the shelf by pulling it forward.
2. Replace the shelf by sliding it back into place.