Program Values - Bosch GWH 2700 ES LP User Manual

Maintenance and service
6.5

Program values

This section describes details on programming the
appliance. For most applications the factory default
values will robust and stable operation. Only adjust the
factory settings if the installation requires changes as
indicated in the appropriate section of this manual.
Program Description
P1 Maximum Power
P2 Minimum Power
P3 Remote Con-
trols installed
P4 Access to Diag-
nostic Mode
P5 Cascade Mode
P6 Temperature
Unit
P7 Appliance Type
P8 Back light
P9 Fan Purge
Table 18 Program values, factory default settings and ranges.
* Incorrect setting causes errors.
36
Factory Default MIN
NG: 48, LP: 46 21
7 7
_0 _0
E 0d
NO NO
°F °F
NO Cd
dE dE
Refer to chapter 6.6 Control board diagnostics (page
37) regarding how to access these P-modes.
Caution: Misadjusted
values can
malfunction, errors, and service
calls.
MAX Comment
NG: 50, LP: 49 see chapter 3.12, page 27.
note: reducing P1 values below
maximum will reduce maximum
power of the appliance.
20 see chapter 3.3.6, page 17
6 see chapter 5.5, page 31
10f see chapter 6.6, page 37
CC contact Bosch for details
°C
NO Condensing / Non-condensing*
ON dE turns back light off after 60
seconds
pushed, ON turns backlight on
permanently
runs secondary and primary fan
when
depressing the "P" - button
program
lead to appliance
from last button
P9 is selected
6 720 608 542
by