Quick Mount PV QBox Installation Manual page 10

Finish Conduit Attach: Tighten conduit hub to
lock conduit in place. The cut edge of the conduit
should be flush with the top of the hub nut or 1/6"
above it. This will hold the QBox flashing in place
when securing it to the roof.
BI 7.2.3-44
10
Secure to Roof: Screw the anchor bolts with
sealing washers through the mounting holes and
into the roof sheathing securing the QBox to the
roof. No pilot hole is required.
11
Close Lid: Close and thread the bolt into the nut
by hand. Then using a #3 Philips drive, turn bolt
until the top and bottom tabs securing the bolt
are flush.
8
12
Nov-2017, Rev 2