Table of Contents
Advertisement
Electronic control center TEMPERATURE
TEMPERATURE
-SIGNAL
LIGHTS
/
DISPLAY
SIGNAL
LIGHT
POWER
SAVER PAD
AUTO
I
TEMP PAD------i
FRMCE
PAD
DISPLAY WARNING
SIGNAL
LIGHTS
TEMPERATURE
ADJUSTING
PADS
NIGHT
/
ICE
"/
'FRZ TEMP 'REF TEMP
'SET
LIGHT PAD'
SELECTION
PADS
PAD
PAD
TEMP PAD
A beep
will be heard each time a control
pad is pressed. The signal light on a control pad will come on
when that control
is first pressed.
Display mode...
The display
mode
is used to demonstrate
the
Electronic
Control Center. Using the display
mode
will also turn off the beeping
from the warning
signals.
The refrigerator
will continue
to operate
normally
while the Electronic
Control
Center
is in
the display
mode.
To start the display
mode,
press and hold the
RESET Pad until two beeps
are heard. While in the
display
mode, the five signal lights will flash. Press-
ing the control
pads during the display
mode will
not change
any settings. However,
if a control pad
is pressed,
you will hear a beep
and the signal
light will come
on.
Power saving pad...
The POWER SAVER Pad on the Electronic
Control
Center
operates
low wattage
electric
heaters
around
the door openings.
These heaters
keep
moisture
from forming
on the outside
of the re-
frigerator
when the humidity
is high.
Setting the temperatures...
When the refrigerator
is first plugged
in, the
freezer
temperature
is preset to 0°F ( -18°C)
and
the refrigerator
is preset to 36°F (2°C).
Give the refrigerator
time to cool down
com-
pletely
before
adding
food.
(This may take sev-
eral hours).
These settings
should
be about
right for nor-
mal household
refrigerator
usage.
The temperatures
will be set about
right when
milk or juice is as cold as you like and ice cream
is firm.
To cancel
the display
mode press the RESET Pad
once. The display
mode will automatically
cancel
after being
on for 8 hours.
NOTE: If the display
mode
is entered
while the
ON/OFF switch
is OFF, "CO"
will show on the dis-
play.
You must set the ON/OFF switch
to the ON
position
before
the refrigerator
will start cooling.
1 When
humidity
is low, press the
POWER SAVER Pad to turn the Power
Saver signal light on. This will turn off
the heaters.
2. If moisture
forms on the outside
of
the refrigerator,
press the POWER
SAVER Pad to turn the Power Saver
signal light off. This will turn the heat-
ers on.
If you need
to adjust
temperatures
in the re-
frigerator
or freezer do the following:
l
Adjust the refrigerator
or freezer temperature.
l
Wait at least 24 hours,
l
If needed,
make
further
temperature
adjust-
ments to the refrigerator
or freezer.
continued
on next page
5
Advertisement
Table of Contents
