Advertisement
The following procedure describes the basic steps needed
to set up the BOSSP80:
1. To set the mode of operation for the BOSSP80 (S1
=off, S2= off). To set up the hardware, connect power to
the power inlet and output devices to the power outlets.
2. To configure the BOSSP80, you can use the console
(HyperTerminal) or WAN port. Connect the BOSSP80 to
a console and a WAN to enable its configuration through
the console or browser menu.
3. Follow these steps to start HyperTerminal and
communicate with the BOSSP80:
1. To start HyperTerminal, click Start, Programs, Accessories,
Communications, and HyperTerminal from the Windows
Start button.
2. A New Connection opens. Type a name for the connection
in the Name field and select an icon for the connection. Click
OK when done.
3. From the Connect using drop-down box, select the COM
port that you have connected to the BOSSP80. Click OK
when done.
4. The Properties window opens. Click Restore Defaults to
use the default settings. Make sure that the Bits per second
field is set to 9600. Click OK when done.
BOSSP80 Quick Installation Guide
- 1 -
Advertisement
