Advertisement
WWW.PEAKWORKS.CA
ASSEMBLY
Step 6
Attach the SRL-33303-50 to the bracket and lock it on
using the detent pin. (FIGURE 8)
(FIGURE 9)
(FIGURE 10)
Step 8
Ensure that all locking pins are in place (6 in
total) and secure. Ensure that the safety chain
has been properly tightened. Your TR-100 tripod
is ready to be used.
(FIGURE 12)
TM
INC
Step 7
Extend the cable of the SRL and pass the snap
hook through the hole in the top of the tripod.
Fit the cable into the groove on the pulley and
secure it with the control pin. (FIGURE 9 & 10)
Step 9
Add a secondary pulley (if required) to any of the
slotted holes on the side of the tripod head to add a
personal or material winch. (FIGURE 12)
5
(FIGURE 8)
(FIGURE 11)
Advertisement
