Omega National Products Contempora Manual

Table of Contents

Download this manual

Contempora Range Hood

• Always read the instructions completely and carefully before beginning assembly.

• Remove and check contents for damage and/or missing parts. Keep the original

cartons and packing materials, which are required for any authorized adjustment by

our dealers.

• These instructions are for reference only. Make sure installation procedures comply

with all applicable building codes in your area.

2 ea.- Chimney Mounting Board

1 ea.- Mounting Board

2 ea.- Mounting Bracket

1 ea.- Contempora Range Hood

1 ea.- Hardware Pack

Patent Pending

Important Notes

1 ea.- Chimney

1 ea.- Range Hood Liner

Form OME-091, 05/2013

Table of Contents

Do you have a question about the Contempora and is the answer not in the manual?

Page 1 Parts List 2 ea.- Chimney Mounting Board 1 ea.- Chimney 1 ea.- Mounting Board 2 ea.- Mounting Bracket 1 ea.- Contempora Range Hood 1 ea.- Range Hood Liner 1 ea.- Hardware Pack Form OME-091, 05/2013 ©Omega National Products...
Page 2 Start 6 each 10-24 x 3/4" screws into the "T" Figure 4 nuts that were previously installed (see fig- ure 4.) The large barbed end of the "T" nuts should be on the opposite side of the Mounting Board. Form OME-091, 05/2013 ©Omega National Products...
Page 3 #6 x 1/2" Truss Head Screws (See figure Step 6: Attach the Mounting Brackets to the Figure 6 Contempora Range Hood with 8 each #10 x 3/4" Pan Head screws. The flange of Mounting Bracket should be to the inside (See figure 6).
Page 4 (These must be done in accordance with all applicable building codes and requirements in your area). Reinstall the blower faceplate and filters. Step 12: Snap the Chimney to the Chimney Mounting Figure 12 Blocks and trim as necessary. Form OME-091, 05/2013 ©Omega National Products...