(
)Control Panel
2
@1
⑳
⑲
⑱
⑪Digital Speed Indicator (Speed)
Preset Speed, Actual Speed, Warning and Error
Codes are displayed to 2 digits. When the motor is
stopped the Preset Speed is displayed, when the
motor is rotating the actual speed is displayed. The
display also displays the error codes when an error
has occurred.
⑫Speed adjustment knob
Steplessly adjustable speed control. Rotating the
knob clockwise will increase rotating speed. Speed
is adjustable from 5,000-30,000min
⑬Start Switch
Starts and stops motor rotation.
⑭Forward/Reverse Switch
Right hand rotation(FWD) and left hand
rotation(REV) are as viewed with the cutting tool
facing the operator.With the cutting tool facing the
operator right hand rotation(FWD) will be clockwise
rotation.
⑮Controller Switch (Auto-Manual)
This switch selects motor/spindle control from the
5
⑰
-1
.
⑮
⑯
Control Panel or from an external source.
●MANUAL:Control Panel
●AUTOqq :External control through
the input/output connector.
⑯Centering Mode Switch (500min
This switch activates the centering mode, which
maintains a constant 500min
centering the tool.
⑰Reset Switch (Reset)
This switch resets and allows restarting of the
motor/spindle after an error has been corrected.
Some error codes will not allow the unit to be reset
until after the power switch has been turned off.
⑱Load Monitor LED (Load)
The motor/spindle load is displayed by 6 LED
Green, 2 Yellow and 1 Red). Continuous operation
is possible with up to all 3 green LED
the yellow LED
run for a short time. Please refer to Section ⁄5 part
4 of this manual for allowable duration of high load
operation.
⑭
-1
-1
spindle speed for
,
s is lit the motor/spindle can only be
⑪
⑫
⑬
)
,
s (3
,
s lit. If one of