Advertisement
IMPORTANT INSTRUCTIONS AND WARNING - Electric Devices
!
WARNING!
When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electrical
shock and personal injury, including the following.
Read all these instructions before operating this product and save these instructions.
GROUNDING INSTRUCTIONS
1. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current
to reduce the risk of electric shock. This tool is equipped with an electric cord with a grounding conductor
and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordnances.
2. Don't modify the plug provided - if it will not fit the outlet, have the proper outlet installed by a qualified
electrician.
3. Improper connection of the grounding conductor can result in electric shock. The conductor with insulation
having an outer surface that is green with or without yellow stripes is the grounding conductor. If repair or
replacement of the electric cord or plug is necessary, do not connect the grounding conductor to a live
terminal.
4. Check with a qualified electrician or service person if the grounding instructions are not completely
understood, or if in doubt as to whether the tool is properly grounded.
5. Use only 3-wire extension cords that have 3-prong grounding plugs and 3-pole receptacles that accept the
tool's plug.
6. Repair or replace damaged or worn cord immediately.
7. This tool is intended for use on a circuit that has an outlet that looks like the one illustrated in Sketch A in
Figure (below)(115V). The tool has a grounding plug that looks like the plug illustrated in Sketch A in Figure
(below).
8. For Installation in Machine Electrical Cabinet or when wiring directry to machine internal power terminal strip:
1) Prease refer to the pin diagram below for the proper wiring configuration. The plug shown is the female plug
that attaches to the E2530 main power inlet.
2) Make sure you test each individual wire to verify proper circuit prior to attaching any wire to the terminal
block. Do not assume wire colors are the same for all power cords.
9. Install an over current protective device of maximum 10 Amp on
the E2530 main power circuit.
10. USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry the current your product will draw.
An undersized cord will cause a drop the line voltage resulting in loss of power and overheating.
Table (below) shows the correct size to use depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
Ampere Rating
More
Than
0
6
10
12
Only the applicable parts of the Table need to be included. For instance,
a 120-volt product need include the 240-volt heading.
1
Grounding Method
GROUNDING
PIN
Minimum gage for cord
Volts
120V
240V
Not
More
Than
6
10
12
16
COVER OF GROUND
OUTLET BOX
(A)
Total length of cord
7.5m(25ft.)
15m( 50ft.)
15m(50ft.)
30m(100ft.)
18
16
18
16
16
16
14
12
Power cord connector
L
E
(B)
30m(100ft.)
45m(150ft.)
60m(200ft.)
90m(300ft.)
16
14
14
12
14
12
Not Recommended
L : Line
N : Neutral
E : Earth
N
Advertisement
