Advertisement
LONG
CONNECTING
PIN
REAR HOLE
0
FRONT
HOLE
DOOR
BRACKET
DOOR
CLOSER
(2) SHORT SCREWS
WARNING
BEFORE locking door bracket,
be sure that lugs on rod are
resting against "Hold-Open •
Washer. This will give proper
tension setting for closer.
AFTER completed installation,
Move "Hold-Open Washer"
back of lugs on rod.
HOLD-OPEN WASHER
HOLD-OPEN WASHER
STEP
2
Attach door bracket to closer with long pin as shown. With door tightly
closed and latched, hold closer and door bracket in level position and mark
center hole of each slot and drill three pilot holes. Fasten to door with two
short screws as shown. Closer is now ready to operate. Open door and
move "Hold-Open Washer" back of lugs on rod. Note: Speed adjustment:
Turn valve clockwise to decrease speed, counter-clockwise to increase speed.
CONTROLLED "EXTRA LATCHING POWER"
Installed as directed above, the closer is in a maximum latching power
position (pin in front hole). If less latching power is required, hold door
open about 8" with "Hold-Open Washer", pull long pin and reconnect in
rear hole.
ANVIL MARKTM
WILMINGTON, DELAWARE
Made In Ta wan
0
Advertisement
