Configuring DHCP or Static IP
To configure your LifeSize Phone for DHCP or Static IP use, follow these steps:
1. Log in to the Admin Menu on your LifeSize Phone.
The Admin Menu provides access to audio, communications, and user preferences. To
access the Admin Main Menu, follow these steps:
a. Press
b. Enter the default admin password 1 2 3 4 and press
2. Press 1 on the keypad to select Preferences.
3. Press 2 on the keypad to select Communications.
4. Press 3 on the keypad to select Network.
5. Set the following values:
DHCP
Choose Enabled to use DHCP for network configuration.
Choose Disabled to use a static IP address.
IP Address
If you chose Disabled for DHCP, enter the static IP address of the device.
Subnet Mask
If you chose Disabled for DHCP, enter the IP subnet mask of the device.
Default
If you chose Disabled for DHCP, enter the default gateway IP address of
Gateway
your network.
6. Press the
button to exit the Admin Menu.
Dialing IP Addresses From Your LifeSize Phone
To place a call using an IP address, follow these steps:
1. Press the
2. Enter the IP address of the device you wish to call using the number keypad.
The LifeSize Phone initiates the call to the far end device.
The call status displays on the LifeSize Phone display.
2005 LifeSize Communications. All rights reserved.
sequentially when the phone is idle.
button on your LifeSize Phone.
.
1