Table of Contents
Advertisement
1.2 For Your Installation
Figure2. Install the product to Pedestal Mount bracket
To install this product, please refer to Figure2 and do the following steps.
1. Make sure the threads of the product and the threads of the supplied M8X15mm stainless steel bo
lts (Supplied) are free of dirt anddebris.
2. Apply an amount of thread locking compound(not supplied) to the thread of the product and the thread
of the bolts.
3. Secure the product to the mounting surface with the adjusted wrench and four M8x15mm stainless
steel bolts and lock washers. Tighten the bolts to 250~350 kgf.cm (24Nm~34Nm)
Note : Figure2 shows the product being installed on a Pedestal mount which is an optional
product (not supplied) and if there is no need the pedestal mount, just follow a above
step to install the product without pedestal mount bracket.
6
Advertisement
Table of Contents
