Aquasana AQ-4050 Instruction Manual

ONCE THE FILTER AND FAUCET ARE MOUNTED and the brass
"T" supply valve is properly attached to the cold water supply
line proceed with the following steps:
A. Connect the hoses as shown in figure A or B.
B. Turn the cold water supply line on this will open the water
supply to the faucet.
C. Check for leaks. If leaks are present, turn off the supply valve
and check all connections.
D. Lift the black lever on the filter faucet as shown below and
allow the water to run until all cloudiness and air bubbles are
gone. this faucet lever can be pushed down for water on
demand or lifted to the upright position for continuous flow.
E. DRINK AND ENJOY!
With Aquasana, you can bottle your own!
aquasana.com
PLEASE NOTE: For the first 72 hours of use you may
notice a slight drip. This is normal and will cease with
use of your new AQ 4000.
Aquasana AQ-4050/AQ-4055
Under-sink Adapter Kits
(for use with the Aquasana AQ-4000
This product can be used only with the supplied faucet
and is not designed to be used in constant pressure
applications, such as ice makers or fountains.