EasyPro EXT Series Installation And Service Manual

Download this manual

Installation and Service Manual

TYPE:

END-SUCTION CENTRIFUGAL

MOTOR:

NEMA 143JM-215JM

PORT SIZE:

3" FLANGED INLET, 2" FLANGED DISCHARGE

HORSEPOWER:

3/4 HP THROUGH 15 HP

HARDWARE:

STAINLESS STEEL

SEAL OPTIONS:

STAINLESS STEEL WITH BUNA AND VITON

WARNING: Please read completely before you install or operate your new pump! Do NOT allow this pump to become

submerged! Never run dry - Never reverse rotation. Never exceed an internal case pressure of: 100 PSI.

EXT Series

for EXT75, EXT180, EXT300, EXT1500

Reliability You Can Count On!

EasyPro

XXXXXXXXX

S/N: XXXX-XXXXXX

Please fill in for future reference:

MODEL: ______________________________________

SERIAL NUMBER: _____________________________

DATE PURCHASED: ___________________________

* Please fill out the warranty registration card in this manual

Pg. 1

Page 1 WARNING: Please read completely before you install or operate your new pump! Do NOT allow this pump to become submerged! Never run dry - Never reverse rotation. Never exceed an internal case pressure of: 100 PSI. Reliability You Can Count On! © 2019 EasyPro, Inc Pg. 1...
Page 2 This will reduce friction losses and maximize output. 5. The EasyPro EXT Series pump is not self-priming! It must not be run dry! We recommend a flooded suction installation. Please read carefully! When properly installed, the EXT Pump will provide dependable, trouble-free service.
Page 3 5. Detach bracket from motor. 6. Remove mechanical seal from bracket by pressing out from the back. Do not dig out from the front! (If you are replacing the seal). Reliability You Can Count On! © 2019 EasyPro, Inc Pg. 3...
Page 4 The exclusive remedies provided hereunder shall, upon EasyPro’s inspection and option, be either repair or replacement of EasyPro shall not be held liable for any loss of fish, plants or any other livestock as a result of any failure or defect of this the Product or parts covered under this warranty.

Ext75Ext180Ext300Ext1500