socomec DIRIS Ap Manual page 8

4 PROGRAMMING OF THE N° 1 ANALOG OUTPUT VALUE AT 20 mA (OUt 1 20 MA HV)
NB: The type default setting is 0 mA (HV 0000). If you want this setting, press
(OUt 2 20 MA TYPE). If not, proceed as follows:
KEYS INSTRUCTIONS
Press once
Press to decrement or on
Press once to confirm value.
Press once to pass to analog output 2 type programming (OUt 1 20 MA TYPE).
NB: the first four digits correspond to the value in decimals and the sixth digit to the weight /, K (kilo) or M (Mega).
Example : programming of 2000 M once entered in the Out 1 20 mA HV
KEYS INSTRUCTIONS
Press once
Press once
Press four times
Press once
NB: for ΣP, ΣQ, ΣS and ΣPF the upper threshold (HV) may correspond to the positive value (example : + 1000 kW).
Press once
8
to increment selected digit value.
. You will pass to type programming
DISPLAY COMMENT
Press as many times as necessary to
move to the right or on to move to
the left.
DISPLAY COMMENT
To display flashing 1
To increment the 1
To display flashing 5
Press again for : M, / and K
To confirm value.
Press
2 type (OUt 2 20 MA TYPE).
st digit.
st digit
th
digit.
to programme analog output
SOCOMEC - Réf. : 875 518 B-GB