Wooden isolation/elevation stands AUX LED indicator RCA LED indicator LED indicator 7. Bluetooth Optical LED indicator USB LED indicator 10. Volume knob Rear Panel Master Speaker 1. Digital optical input jack 2. USB input jack 3. On/standby On/standby switch 4. 3.5mm TRS input jack 5.
INSTALLATION 1.Ensure that the Power Switch on the rear panel of the Master Speaker is in the OFF position. 2.Plug one end of the included Speaker Connection Cable into the Speaker Input Connector on the rear panel of the Slave Speaker, then plug the other end into the Speaker Output Connector on the rear panel of the Master Speaker.
BLUETOOTH PAIRING Perform the following steps to pair your mobile device with the speakers. 1. Flip the Power Switch on the rear panel of the Master Speaker to the ON position. The LED Indicator on the front panel will illuminate. Select BT by short pushing the volume knob (SOURCE on IR remote) until reaching the BT position (this will be visible through a slowly blinking white LED).
OPERATION Note that the output of the speakers is the sum of all inputs. Unless you specifically want to listen to a mix of different sources, only one audio input should be in active use at a time. 1. Rotate the Volume Knob on the Master Speaker fully counterclockwise. 2.