Troubleshooting - JVC TH-LB2-B Instructions Manual

Troubleshooting

If you have a problem with this System, check this list for a possible solution before calling for service.
Power
Power does not come on.
The unit suddenly turns off.
Remote control
The remote control does not work.
The remote control of the TV does not work.
External components
No sound can be heard when DIGITAL 1 or
DIGITAL 2 is selected as a source.
iPod
iPod cannot be connected firmly.
iPod does not provide sound.
iPod cannot be charged.
=
The power cord is not inserted securely. Plug it in securely.
=
Auto power save function is on. Refer to "Activating/deactivating APS
(Auto Power Save)" in "Basic operation."
=
Pull out the insulation sheet.
=
Sunlight is shining directly on the remote sensor. Hide the remote
sensor from direct sunlight.
=
The path between the remote control and the remote sensor on the
front panel is blocked.
=
Point the remote control at the remote sensor on the front panel.
=
Signals cannot reach the remote sensor. Move closer to the unit.
=
The battery is exhausted. Replace the battery.
=
If you installed the unit in front of the TV, connect the TV remote pass
through cable (supplied).
=
Check the output setting of the connected digital components. Set the
output setting to PCM signal. (Refer "Specifications" on page 10 for
more information.)
=
Check to see whether the connector between iPod and the unit is not
damaged, and connect it.
=
iPod is not properly connected. Remove iPod from the unit, and then
connect it again.
=
iPod is not properly connected. Remove iPod from the unit, and then
connect it again. After connecting iPod, turn on the power again.
9