Advertisement
Safety and Warnings
Assembly & User Instructions - Please keep for future reference
Use protection equipment: helmet, gloves, kneepads, and
elbow pads.
Be cautious when using the product, as it requires much skill
in order to avoid accidents brought about by falls or collisions
by the users or third parties.
Do not touch the motor when in use or directly after use as it
can become very hot.
gear, wheels and all other moving components.
Do not use the scooter in wet weather. Never ride on it
through water, and never immerse it in water; electrical and
drive could be damaged by water or create other possible
unsafe conditions.
For safety use, it is not suitable for children under 6 years.
User weight more than 40kg may damage the scooter.
Be sure the rider keeps both hands on the handlebars and stand on
the center of the deck at all times while riding.
Do not activate the go button unless you are on the scooter and in a
safe environment that is suitable for riding.
Do not attempt or perform stunts or tricks on this electric scooter. This
product is not made to withstand abuse from jumping, curb grinding or
any other type of misuse or stunts.
Never allow more than one person at a time to ride the scooter.
Never use near steps, water, or swimming pools.
Never ride while using a cell phone or wearing headphones.
Never hitch on to or with another vehicle or pull anyone or anything.
Never immerse the scooter in water; electrical and drive components
could be damaged by water or create other possible unsafe
conditions.
without loose debris, such as sand, leaves, rocks or gravel. Water,
mud, ice, bumpy, uneven, slick, or rough surfaces could impair traction
and contribute to possible loss of control. Avoid excessive speeds that
can occur from downhill rides which could cause loss of control.
Do not ride at night or in areas of limited visibility.
Before each ride the following checks will need to be performed
to the scooter:
• That all components are properly secured and are functioning
• Components shall be maintained and repaired in accordance with
the manufacturers authorized replacement parts with installation
performed by dealers or other skilled individuals.
USING THE BATTERY CHARGER
The battery charger should be regularly examined for damage to the
cord, plug, enclosure and other parts. In the event of such dam age,
if any is found, the scooter should not be charged until the battery
charger has been repaired or replaced.
Use only with the supplied recommended battery charger.
Always pay attention to the charger when charging.
The battery charger is not a toy and should be operated by an a dult.
Disconnect the battery charger and unplug from scooter
when not in use.
Do not exceed recommended charging time.
Always disconnect the battery charger from the scooter prior
to wiping down and cleaning with any liquid.
FAILURE TO HEED TO THE WARNINGS LISTED ABOVE
INCREASES RISK OF POTENTIAL SERIOUS INJURY.
USE THE APPROPRIATE CAUTION WHEN RIDING AND
ALWAYS WEAR PROTECTIVE GEAR.
THERMAL FUSE
This product is equipped with a built in thermal fuse that
will activate if the motor is overloaded. This self-resetting
fuse will automatically reduce power to the motor when it
becomes overloaded. Overloading of the fuse can occur
from any one or a combination of the following:
• Rider exceeds the maximum weight limit
• Riding up steep inclines
• Pulling or towing anything behind the scooter
WARNING:
unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
s.
Advertisement
