Barracuda CloudGen Firewall Revision

Barracuda CloudGen Firewall Revision

Advertisement

Barracuda CloudGen Firewall
Barracuda NG Firewall F10 Revision A
https://campus.barracuda.com/doc/12198249/
Opening your Barracuda Networks appliance or removing its warranty label unless instructed to
do so by Barracuda Networks support will void your warranty and hardware support.
Barracuda Networks Appliance Safety Instructions
Always use the power supply shipped with the appliance.

General

Front
Back
Minimum
Firmware
Requirement
Default Port Configuration
Label OS Notation Speed/Type
1
port1
2
port2
3
port3
4
port4
Hardware Specifications
Component
Barracuda NG Firewall F10 Revision A
Management Port
10/100 MBit RJ45
10/100 MBit RJ45
10/100 MBit RJ45
10/100 MBit RJ45
Specifications
Revision A
X
1 / 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CloudGen Firewall and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Barracuda CloudGen Firewall

  • Page 1 Barracuda CloudGen Firewall Barracuda NG Firewall F10 Revision A https://campus.barracuda.com/doc/12198249/ Opening your Barracuda Networks appliance or removing its warranty label unless instructed to do so by Barracuda Networks support will void your warranty and hardware support. Barracuda Networks Appliance Safety Instructions Always use the power supply shipped with the appliance.
  • Page 2 The hardware specifications list was valid at the time this manual was published. The listed components are subject to change at any time, as Barracuda Networks may change hardware components due to technological progress. Therefore, the list may not reflect the current hardware configuration of the Barracuda Networks NG Firewall or NG Control Center appliance it...
  • Page 3 Installation was completed successfully, appliance is halted for Green Steady reboot or installation was not yet Barracuda NG Firewall is up and running. initialized far enough for LED control. An error has appeared preventing Barracuda NG Firewall from entering the Blinking Error during installation.
  • Page 4 Barracuda Networks Inc. All specifications are subject to change without notice. Barracuda Networks Inc. assumes no responsibility for any inaccuracies in this document. Barracuda Networks Inc. reserves the right to change, modify, transfer, or otherwise revise this publication without notice.

This manual is also suitable for:

Ng firewall f10

Table of Contents