Table of Contents
Advertisement
Replacing
Burn, Electrical
Shock and Fire Hazard
l
Make sure all surface
units are OFF before
replacing
surface
units and
reflector
bowls.
Failure to do so can result in burns or electrical
shock.
l
Do not line the reflector
bowls with foil. Fire or electrical
shock
could
result.
2. Line up openings in the reflector
bowl with the surface unit recep-
tacle and the element hold down
1.
Turn off all surface units
clip.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle.
Push
the surface unit terminal into the
receptacle.
1
4. When terminal is pushed into the
receptacle
as for as it will go, push
down the edge of the surface unit
opposite the receptacle.
The ele-
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector
bowls reflect
heat back
to the utensils
on the surface
units. They also help catch
spills. When they are kept clean,
they reflect
heat better
and look new longer.
If a reflector
bowl gets discolored,
some of the utensils
may not be flat
enough,
or some may be too large for the surface
unit. In either case, some
of the heat that's meant
to go into or around
a utensil goes down and heats
the reflector
bowl. This extra heat can discolor
it. See Cooking
Guide for
further
information.
Advertisement
Table of Contents
