FAME LS-1 ECO TRAY User Manual page 11

3. Next, connect two of the L-sides, one with rubber molds and one without.
Make sure that the two L-sides are facing from the same side. The base and the
rubberized part of each L-sides should face same direction. Place the parts on
top of each other as follows: lower L-sides (without molds), upper L-sides (with
molds), shelf. Insert a screw through the outter part and screw into the support
bar inside.
4. Repeat the steps for the L-sides,
the shelf and the support bar for the
other side.