Advertisement
Instructions for Extending a 2945A Post
1.
Loosen the two ¾" screws on top pipe section (near grade line at bottom of
pipe)
2.
Pull apart the upper section from the lower pipe section.
3.
Place new extension coupling with new extension pipe over the existing
lower pipe section.
4.
Tighten screws provided on the extension pipe and lower pipe (3/4" X 1"
square head screw).
5.
Take existing stem and place the new extension stem with coupling on top
of original stem.
6.
Drill through stem and coupling (pilot holes provided on one side), then pin
together with pins provided (1/4" X 3" br. cotter keys.)
7.
Place stem down the inside of new extension and lower pipe assembly
aligning it on the 2" square nut on valve.
8.
At this time, remove top section (with operating nut assembly) from off the
top of indicator post standpipe (two bolts).
9.
Place complete upper section over top of stem and align with the new
extension pipe.
10.
Push together, adjust to desired height, and retighten the two ¾" screws in
top pipe section.
11.
Stem should be cut 7"-10" above the pipe.
12.
Adjust open/shut plates per instructions and replace top section wit hstem
nut (can also be extended at bottom end).
Advertisement
