Gait up GO Instructions For Use Manual page 29

The Physilog6 sensor device accessory is worn either at the belt or on a foot depending on the
test. Therefore two fixation clips are provided with the sensor device: a belt and a shoelace
clip.
To fix the Physilog6 sensor device in the belt clip, place the Physilog6 on the belt clip. The
sensor device can be clipped into the fixation clip in both directions. You need to clip the
fixation connector on the upper part of the fixation clip first, then push the lower half of the
Physilog6 sensor device until you hear a clicking sound. Once the sensor is attached to the
fixation clip, it is possible to place the clip at the belt of the test subject. The clip must not
touch the participant's skin, use the belt strap over the clothes if the subject is not wearing a
belt. Carefully read the instructions given in the Gait Up GO Mobile Application for the selected
test to know where to place the sensor.
Fig 15: Sensor fixation using the belt clip
To fix the Physilog6 sensor device on the foot, use the shoe lace clip. Insert the clip without
the sensor device under the shoe laces. Take two rows of laces when possible to have better
attachment. Then place the Physilog6 sensor device on the clip. You need to clip the fixation
connector on the upper part of the fixation clip first, then push the lower half of the Physilog6
sensor device until you hear a clicking sound. The sensor can be placed on the shoe without
restrictions of orientation and position.
Fig 16: Sensor fixation using the shoe lace clip
ENGLISH 29/51