lock washers (item #5), flat washers (item #3),
and 1 taptite (item #7) with flat washer (item #3)
as shown in Fig. 2. (Leave hardware loose.)
7. Move and hold slide assembly back.
8. Extend key lock bolt.
locks & keys
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible
contingency to be met in connection with installation, operation or maintenance. Should further information be desired or
should particular problems arise which are not covered sufficiently for the purchaser's purposes, the matter should be
referred to the General Electric Company.
GE Industrial Solutions
41 Woodford Ave.
Plainville, CT 06062
www.geindustrial.com
© 2012 General Electric Company
All Rights Reserved
Fig. 2
Number of
Key removable when:
Key Location
1
Lower
2
Upper
Lower
2
Upper
9. Release slide assembly and allow it to return.
10. Torque hardware to 7-9 Ft-Lbs.
11. Retract key lock bolt.
12. After assembly, assure slide assembly moves
freely.
If fixed cam is adjusted, drill
hole and re-install roll pin.
Bolt Location
Extended
KR1007510
Extended
Withdrawn
KR1007521
Extended
Extended
KR1007520
2
Fixed Cam
Fig. 3
Kirk key
interlock
DEH – 158 R04 06/12