Important Notes; Pairing A Bluetooth Device; Specifications - ION BLOCKROCKER BLUETOOTH Quick Start Manual

IMPORTANT NOTES

Use this troubleshooting guide if:
The sound is distorted at high volumes.
The sound is distorted: Try lowering the volume control of your sound source or music instrument. Also, try to
reduce the overall volume of BLOCKROCKER.
There is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This
will allow you to play the music louder before clipping (distortion) occurs.
There is a high-pitched whistling noise when using microphones: This is probably feedback. Point the
microphones away from the speaker.

PAIRING A BLUETOOTH DEVICE

Turn on your Bluetooth device.
1.
Power on BLOCKROCKER and it will automatically go into pairing mode to search for Bluetooth devices.
2.
Navigate to your Bluetooth device's setup screen, find "ION Audio Speaker" and connect.
3.
BLOCKROCKER LED will light up solid when it is 'paired'.
4.
To disconnect pairing, press the 'Disconnect' button on BLOCKROCKER.
5.
To connect to another Bluetooth device, repeat steps 3-4.
6.
Note: You can pair with a smartphone, iPhone, iPad, computer, or Android*** device equipped with Bluetooth that
supports A2DP.

SPECIFICATIONS

Input Voltage: AC 100-120V/ 60Hz 220-240V/ 50Hz
Input Wattage: 50W
Output Wattage: (RMS) 18W, 1%THD, (Peak) 22W
Frequency Response (±3dB): (Aux) 77Hz-20kHz
Bottom pole mount specifications: Standard Pole Mount found at professional audio retailer:
Depth 80mm (3.15")
Diameter 35.5mm (1.40")
Time required to fully charge the BLOCKROCKER: under 6 hours
Battery life: Over 12 hours at full volume of the BLOCKROCKER when fully charged.
Note: Battery life may vary based on temperature, age, and volume usage of product.
Radio Frequency Range:
US:
AM 520 – 1710 KHZ
FM 87.5 – 108 MHZ
EUROPE:
AM 522 – 1629 KHZ
FM 87.5 – 108 MHZ
JAPAN:
AM 520 – 1710 KHZ
FM 75.5 – 90.5 MHZ
For the electrostatic discharge (ESD) test of EN301 489-1/17, it was found that manual
operation is needed to resume normal operation as intended after the test.
5