PLEASE READ THE MANUAL THOROUGHLY PRIOR TO EQUIPMENT SET-UP, OPERATION AND MAINTENANCE. INSTALLATION/ OPERATION IMPORTANT!!! PLEASE READ BEFORE INSTALLATION ■ If the unit has recently been transported please let unit stand still for a minimum of 24 hours before plugging it in. ■...
persons All electrical work must be carried out by suitably qualified ELECTRICAL Please ensure that the required voltage of the compressor is being supplied at all times. Low or high voltage can detrimentally affect the refrigeration unit. All units should be plugged into a grounded and properly-sized electrical outlet with appropriate overcurrent protection.
DEFROST SYSTEMS Refrigerator coils are kept below the freezing point (0 C). During compressor down-time, the evaporator fan continues to circulate air through the evaporator coil. This air circulation raises the coil temperature above the freezing point, melting any accumulated frost.
PROPER GROUNDING REQUIRED ■ To minimize shock and fire hazards, make sure that the unit is properly grounded. PROHIBITION ■ Do not attempt to remove or repair any component unless instructed by factory. ■ Make sure that the unit is not resting on or against the electrical cord and plug. ■...
CLEANING THE UNIT ■ When cleaning the cabinet interior, use a solvent of warm water and mild soap. ■ Do not use steel wool, caustic soap, abrasive cleaners, or bleach that may damage the stainless steel surface. ■ Wash door gaskets on a regular basis, preferably weekly. Simply remove door gasket from the frame of the door, soak in warm water and soap for thirty (30) minutes, dry with soft cloth, and replace.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible. Pentland Wholesale Ltd, Blizzard house, Unit17 Walker Park Industrial Estate, Walker Road, Blackburn, Lancs, BB1 2QE. Tel: 01254 614444,...
R290 refrigerant is used for this equipment. Caution! Consult repair manual/owner’s guide before attempting to install or service this product. All safety precautions must be followed. Dispose of properly in accordance with federal or local regulations. Risk of fire or explosion due to puncture of refrigerant tubing.
Need help?
Do you have a question about the HW400 and is the answer not in the manual?
Questions and answers