Whirlpool FGS335E Use & Care Manual page 12

Although your new oven is properly adjusted to
provide accurate temperatures, it may cook faster
or slower than your old oven.
If you are not satisfied with the baking/roasting
results, you can change the temperature calibration
by following the steps below.
NOTE: DO NOT measure the oven temperature with
a thermometer. Opening the oven door will lower the
oven temperature and give you an incorrect reading.
Also, the thermometer temperature reading will
change as your oven cycles.
1.
Make sure the oven temperature control knob is
turned to the off position. Pull the knob straight
off and flip it over.
m
2. Loosen the locking screws inside the
control knob.
Note the position of the notches.
Locking
screws
3. Adjust the temperature.
A
0 To lower the temperature, hold the knob
I
handle firmly and turn the skirt counterclock-
wise to move the tooth a notch to the "E" on
To lower
the 'COOLER" arrow.
0 To raise the temperature, hold the knob
handle firmly and turn the skirt clockwise to
move the tooth a notch to the "E" on the
"HOTTER" arrow.
Each notch equals about 5°F.
Notches
Skirt
\Tooth
4. Tighten the locking screws and replace the
control knob.
Locking
12