Download Print this page

Whirlpool FGP300BL0 Installation Instructions Manual page 7

30" freestanding gas range

Advertisement

If range does not
operate...
l
Check that the circuit breaker is not
tripped or the house fuse blown.
l
Check that power supply cord is
plugged into wall receptacle.
l
Check that the gas supply is turned
on.
NOTE:
Refer to Use and Care Guide for
operaltng instructions and cleaning
instructions.
Personal Injury/
Product Damage Hazard
~ Do Not step, lean or sit on the range
drawer or door.
Failure to follow these instructions
could result in personal injury
and/or product damage.
For cleaning and
maintenance...
If removing the range is necessary for
cleaning and maintenance,
shut off gas
supply to the range. Disconnect the gas
and electrical supply.
If the gas or electrical supply is
inaccessible, lift the range slightly at the
front and pull the range away from the
wall. Pull the range out only as far as
necessary to disconnect the gas and
electric supply lines.
Remove the range to complete
cleaning or maintenance.
Move range back into operating
position. Level the range. Connect the
gas line to the range and check for
leaks. Plug electric power supply cord
into outlet.
Make sure the anti-tip bracket overlaps
range base.
If you need
as&stance...
Check your Use and Care Guide for toll-
free number to call, or call the dealer
from whom you purchased this
appliance.
The dealer is listed in the
Yellow Pages of your phone directory
under "Appliances
- Major."
When you call you will need the range
model and serial number. Both numbers
can be found on the serial/rating
plate
located under the maintop.
Part No. 07716400/4363355
0 1994
Benton
Harbor, Michigan
49022
Printed on recycled
paper.
10% post consumer
waste/
50% recovered
materials.
Printed in U.S.A.

Advertisement

loading