Electronic Oven Control; Display; Start; Off/Cancel - Whirlpool 8522773A Use And Care Manual

1. Display

2. Timer

3. Clock

Display
When power is first supplied to the appliance, "PF" will appear on
the display. Press OFF/CANCEL to clear.
Any other time "PF" appears, a power failure has occurred. Press
OFF/CANCEL and reset the Clock if needed.
When the oven is not in use, the display shows the time of day.
When using COOK TIME (on some models,) the display will show
either hours and minutes, or minutes and seconds.
The START pad begins any oven function. If not pressed within 5
seconds after pressing a function pad, the "START?" indicator
light will flash as a reminder. On some models, "START?" will
appear on the display.
If not pressed within 4 to 5 minutes (depending on your model)
after pressing a function pad, the oven display will return to the
time of day mode and the programmed function will be
cancelled.

Off/Cancel

The OFF/CANCEL pad stops any function except the WARMING
DRAWER, Timer and Control Lock.
To Set:
Before setting, make sure the oven and Timer are off.
1. Press CLOCK.
2. Press the HR or MIN "up" or "down" arrow pads to set the
time of day, including a.m. or p.m.
3. Press CLOCK or START.

ELECTRONIC OVEN CONTROL

4. Auto Clean
5. Oven Light Pad
6. Sequence Programming
(on some models)

Start

Clock
B C E
S A
7. Oven Settings
8. Warming Drawer
(on some models)
9. Temperature
Tones are audible signals, indicating the following:
One tone
Valid pad press
Oven is preheated
Function has been entered
Three tones
Invalid pad press
Four tones
End-of-cycle
Reminder, repeating each minute after the end-of-cycle tones
Reminder Tones
Reminder tones may be turned off. Press and hold STOP TIME
for 5 seconds. "rEP" will appear in the 3-digit display and "OFF"
will appear in the 4-digit display. Repeat to turn reminder tones
back on.
All Tones
All of the above tones are preset on, all except the end-of-cycle
tones can be turned off.
To Turn Off/On: Press and hold START TIME for 5 seconds. A
tone will sound and "Snd OFF" will appear on the display. Repeat
to turn tones on and "Snd on" will appear on the display.
Tone Pitch (on some models)
The pitch is preset at high, but can be changed to low.
To Change: Press and hold WARMING DRAWER for 5 seconds.
A tone will sound and " Snd LO" will appear on the display.
Repeat to change and "Snd Hi" will appear on display.
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Press and hold CUSTOM BROIL for 5 seconds. A
tone will sound and "°C" will appear on the display. Repeat to
change back to Fahrenheit. To exit mode, press OFF/CANCEL.
10. Timed Cooking
11. Hour/Minute
12. Start/Control Lock
13. Off/Cancel

Tones

Fahrenheit and Celsius

11