Settings On Presence Detector “Air”; Remove Protection Film On Air Optic Module; Adjust The Angle Of Inclination Of The Optic Module Air - Record RIC 290 Mounting And Adjustment Instructions

SETTINGS ON PRESENCE DETECTOR "AIR"
6
• One has to make sure that the adjustments selected comply with the standard
in force applied.
• The presence detector features a permanent test function, with which its
flawless operating can be controlled several times during every cycle by
means of the bus-connection to the system 20 door control.

Adjust the angle of inclination of the optic module AIR

6.2
-
6.6
The inclination angle of the AIR
optic module has a setting
range from -5° to +10°.
Factory setting: 0°
Adjust light curtain as near as
possible to the moving door
leaves.
+
Please note the background is
modified through this operation
and needs to be learnt again.

Remove protection film on AIR optic module

6.1
ANSI 156.10-2011: Sensor application on sliding doors
6.3
Remove the protection film from
the AIR optic module.
Do not touch or soil the
lenses with the fingers!
If the inactive area exceeds 3 in.
from the face of the door, it shall
have a minimum of two photo
electric beams on one side of
the door and they shall remain
active from fully open to within 6
in. of closed door.