Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Delta Tau Accessory F1
Summary of Contents for Delta Tau Accessory F1
- Page 1 USER MANUAL Accessory F1 UMAC 24Vdc INPUT POWER SUPPLY 3Ax-603909-xUxx August 23, 2006 Single Source Machine Control Power // Flexibility // Ease of Use 21314 Lassen Street Chatsworth, CA 91311 // Tel. (818) 998-2095 Fax. (818) 998-7807 // www.deltatau.com...
- Page 2 Copyright Information ©2006 Delta Tau Data Systems, Inc. All rights reserved. This document is furnished for the customers of Delta Tau Data Systems, Inc. Other uses are unauthorized without written permission of Delta Tau Data Systems, Inc. Information contained in this document may be inaccurate due to product improvements and may not conform in every respect to former products.
- Page 3 REVISION HISTORY REV. DESCRIPTION DATE APPVD FUSE & OPERATING SPEC REVISIONS 08/23/06 J. SCHATZ...
-
Page 5: Table Of Contents
Accessory F1 Table of Contents INTRODUCTION ...............................1 SETUP OF ACC-F1 ..............................2 POWER LED DISPLAY ............................2 JUMPERS ..................................3 FUSE.....................................3 CONNECTOR PINOUTS............................4 Connector P1 – Backplane Interface Connector.......................4 Connector TB1 – User Supplied Power Input Connector..................4 Connector TB2 – Power Supply Output Tap......................4 SPECIFICATIONS ..............................5... -
Page 7: Introduction
Accessory F1 INTRODUCTION The ACC-F1 power supply module is an accessory card that provides the UMAC backplane with system operating power. The purpose of this accessory card is to allow a UMAC application to operate at a low voltage of 24Vdc. -
Page 8: Setup Of Acc-F1
Accessory F1 SETUP OF ACC-F1 The ACC-F1 UMAC power supply comes from the factory configured to operate in the UMAC rack. The 5Vdc remote voltage sense is configured to operate in the factory default configuration. This power supply should only need to be plugged in at the power supply connector of the UMAC back plane. -
Page 9: Jumpers
Accessory F1 JUMPERS Jumpers are configured as follows: Pin# Signal Name Factory Setting SENSE- Jumper Installed SENSE+ Jumper Installed FUSE Fuse F1 is a 7A Slo-Blo type fuse. This fuse is a 3AG 7A or 313007 (Littelfuse) ¼” x 1 ¼” cartridge fuse and is user replaceable. -
Page 10: Connector Pinouts
Accessory F1 CONNECTOR PINOUTS Connector P1 – Backplane Interface Connector This is a ERNI connector. This is the UMAC power supply interface connector. Pin# Signal Description Name CHGND Chassis GND SENSE- 5Vdc Sense- input SENSE+ 5Vdc Sense+ input Not Used... -
Page 11: Specifications
Accessory F1 SPECIFICATIONS Please note that these are design specifications. Performance may differ slightly from these design specifications. Environmental Specifications Description Unit Specification 0°C to 45°C, Operating Temperature ºC 41°C to 70°C derate to 50% Storage Temperature ºC -25°C to 70°C... -
Page 12: Power Supply Output Specifications
Accessory F1 Power Supply Output Specifications Description Unit Specification Power Output 80W without fan 115W with fan +5Vdc @ 14A with fan DC Output V @ A +15Vdc @ 1.5A with fan -15Vdc @ 1.5A with fan The power supply has a replaceable cartridge slow-blow fuse rated at 7A. Replace only with same rated fuse.