Advertisement
Operating instructions.
Throughout this manual, features and appearance may vary from your model.
CZD
• Add fabric
softener to the fabric
• Loosely add items
around in.fusor
T M.
, Select wash cycle.
softener dispenser; see page 7.
Overloading
may neqatively
impact
, Select wash options,
• Add detergent.
GE recommends
wash performance.
_ee page 8 for
including
Fabric Softener
the use of High Efficiency
_
suggested
loading examples,
option.
detergents
in all Energy
, Close lid.
, Select options
including
Star-rated
washers.
NOTE: Washer
will not fill with lid
Pretreat/Bleach
option.
open.
Unlock
Lid
Power
Step 4
, Press Start.
Press to "wake up" the display. If the display is active, press to put the washer into idle mode.
NOTE: Pressing POWERdoes not disconnect the appliance from the power supply.
Start and Unlock Lid
PressStart to begin the cycle.NOTE:The lid must be closed for the washer to fill and the cycle to start. If the lid is open, "UD" will scroll across
the display. If the lid is closed,the lid will lock, the LID LOCKEDlight will light, the detergent will be dispensed, and "FILL"will scroll across the
display.
Pressing Unlock Lid will Pause the cycle and the Start indicator light will blink.
To continue the cycl< press Start again. If machine is paused more than 2/4hours, the cycle will be cancelled. If water remains in the machine,
select the Drain & Spin cycle to drain tub and spin water out of the washer tub.
Display and Status Lights
Display:
The display shows the approximate time remaining until the end of the cycle.
NOTE:The cycle time is affected by how long it takes the washer to fill. This depends on the water pressure inyour home. The "smart" timer
"learns" the amount of time it takes to fill your washer and adjusts the total time accordingly.
In addition, this display will, "scroll" the washer status:
bALANCINg
Start of rebalancing cycle to redistribute clothes. Stops after rebalancing is complete.
CYCLE PrEP
Sensing dry load size prior to fill (normal).
• dELAY
When Delay Wash is initiated. Replaced with estimated time when cycle starts.
End
Endof current cycle.
ES
Washer in a delay start (4 hour maximum) awaiting lower energy rates (seethe Energy Smart section).
FILL
For the first/45 seconds of a fill, the estimated end of cycle time is displayed. For the rest of the fill time, "FILL"is scrolled
until the fill completes.
H20 SUPPLY Can not sense water level (valvespossibly turned off).
HEAt
Water being heated for Sanitize cycle.
• Lid
Cycle stopped because lid is open. Closethe lid.
LOAdSenSE
Sensing wet load size(normal).
PAUSE
Cycle paused because the StardPause button was pressed and the washer was set to Pause. PressStart button again to
restart the cycle.
Cyclestatus lights:
Shows whether the washer is inthe SOAK,WASH,RINSEor SPIN cycle.
Feature status lights indicate (seesections F, G and H for more details):
V The My Settings feature is on for this cycle.
6 Thewasherislocked-willblinkonceifyoupressanybuttonorturnthecycleknob.
_
Thelidislocked. SeetheControlLock
description.
_1_)) The signal is on. Seethe Variable Signal description.
The eWash feature is selected.
Energy smartThe Energy Smart feature is selected. SeeAbout Appliance Communication section. _
A Delay Wash time is set.
Advertisement
