Advertisement
Note 1: The recommended location for the undercabinet light fixture is
near the front edge of the cabinet as shown in fig.1. This provides
the best light distribution across the countertop.
Note 2: Sensor control unit can be connected at the beginning, middle,
or end of a series. Additional sensor units (sold separately) can be
connected to a single series to provide multiple control points if desired.
MOUNTING THE SENSOR CONTROL UNIT:
Note: The sensor control unit can be mounted using double sided
tape or by using included mounting hardware as follows.
(For double-sided tape mount only):
3. Take out the short double-sided tapes from the hardware package
and stick them at the two slots of the sensor for fixing the sensor to
the mounting surface securely. (See Fig. 2)
4. Please remove the white tape before install and stick the sensor
control to the mounting surface securely. (See Fig. 2)
(For hardware mount only):
5. Use a small, flat-head screwdriver to gently pry open the decorative
cap. (See Fig. 3)
6. Place the motion sensor on the mounting surface and mark surface
through the mounting hole. Remove the motion sensor from the
mounting surface. Pre-drill hole into the surface. (See Fig. 4)
7. Hold the sensor in place and tighten the wood screw with a Phillips
head screwdriver. (See Fig. 4)
8. Push the decorative cap firmly into place. (See Fig. 4)
MOUNTING THE PUCK LIGHTS:
Note: Puck lights can be mounted using double sided tape or by using
included magnet & mounting hardware as follows.
(For double-sided tape mount only):
9. Take out the long double-sided tapes from the hardware package
and stick them at the two slots of the puck lighting for fixing the puck
lighting to the mounting surface securely. (See Fig. 5)
10. Please remove the white tape before install and stick the puck
lighting to the mounting surface securely. (See Fig. 5)
(For hardware mount only):
11. Attach the metal disk to the mounting surface, secure it with a
mounting screw. (See Fig. 6)
12. There is a magnetic disk on the back of each puck light. To attach
the puck light to the cabinet, simply align the center magnet with
the metal disk and ensure puck is fully engaged & sitting flush
against the bottom surface of cabinet. (See Fig. 7)
13. Attach the linking cord to the input receptacle on one end of the puck lighting and motion sensor, The 2 receptacles
are designed to only accept a specific plug. (See Fig. 8)
NOTE: The linking cord will only plug into one end correctly. Do not try to force it into the wrong receptacle as this
could cause damage to the fixture.
Note:If the linking cord sags. Peel away the waxed paper on the cable clip and stick to the bottom of the under cabinet.
Fasten the 12" linking cord with the cable clip. (See Fig. 8)
Fig.1.
Page 2 / 4
Cabinet
Counter Top
Fig.2.
Short Double-sided Tape
Motion Sensor
Mounting Hole
Decorative Cap
Fig.3.
Fig.4.
Pre-drilled Hole
Wood Screw (E)
Decorative Cap
Fig.5.
Long Double-sided Tape
Metal Disk (D)
Fig.6.
Mounting Screw (C)
Slot
Sensor
Mounting Hole
Magnet
Puck Lighting
150414
Advertisement
