Download Print this page

Radio Equipment - Acer SpeedWing MiniTwin 250 Assembly Instructions Manual

MiniTwin 250

Thank you for choosing the MiniTwin 250 as your next project. This kit is easy to build and

only requires a few hours to complete. Once finished, you will be rewarded with a stable,

FAST, fun to fly wing that you can take anywhere. It is the perfect "take to work" plane to fly

on those lunch breaks or to stop by the park on the way home. Although this kit isn't

recommended for beginners because of its high speed and agility, once you master the basics

of flying R/C planes you can handle this plane. Well lets get started. Below is a list of supplies

and tools needed to complete the MiniTwin 250.

• Velcro Tape (for battery attachment)

• Dubro Micro EZ-Connects (for servo horns)

• Pen

• 5 minute epoxy

• 320 grit sand paper (or equivalent)

• Hobby knife

• Dremel Tool (optional)

• Thin CA (superglue)

• CA Accelerator (optional)

• Two sided foam tape (for servo anchor)

• 3M #600 3/4" tape (for hinges)

• Covering tape or Low Heat iron on covering

• 3M 77 Spray Adhesive

• 1" wide fiberglass strapping tape (found at Home Depot)

• Micro receiver (GWS 4P , Berg 4 DSP)

• Micro Servos - 2 ( HS-55 recommended)

• Small Speed Control (20 amp) or 2,7-10 amp speed controls for Rudder Operation

• 7-cell NiMh Battery (KAN 1050) or 2, 2-cell 1200-2100 LiPoly batteries or 2-cell

Thunder Power LiPoly

• V-tail mixer (optional for Rudder operation if you don't have a mixing Computer Radio)

ASSEMBLY INSTRUCTIONS

Supplies

Radio Equipment

- by Acer

2100