Cisco WAP125 Manual page 2

Reboot and reset to factory default settings

Hide thumbs Also See for WAP125:

Note: The POWER button only works if the device is using a power adapter. If power is

supplied through Power over Ethernet (PoE), unplug your Ethernet connection for three

seconds then plug it back.

Press the Reset button for about three seconds only, or until the lights go off.

Note: In both above images, the WAP125 is pictured.

Reboot through the Web-based Utility

Step 1. Log in to the web-based utility of your WAP and choose Administration > Reboot.

Wap581