AEG FD360V User Manual page 28

28 www.aeg.com
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to
keep the salt refill indicator active.
Multi-tabs containing salt
are not effective enough to
soften hard water.
How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold the programme button until the
indicator
indicators
on.
2. Wait until the indicators
the indicator
indicator
intermittent flashing of the indicator
shows the current setting.
• e.g. 5 flashes + pause + 5 flashes
= level 5.
3. Press programme button repeatedly
to change the setting. Each pressing
of the programme button increases
the level number. After reaching level
10, the count starts again from level
1.
4. Press the on/off button to confirm
the setting.
6.3 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
flashes and the
and are
and are off and
flashes. The
still flashes. The
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold the programme button until the
indicator
indicators
on.
2. Press the programme button
immediately.
• The indicator
on.
• The indicator
flashes.
3. Wait until the indicator
are off. The indicator
still flashes.
• The indicator shows the
current setting:
signal off.
4. Press the programme button to
change the setting.
• on = Acoustic signal on.
5. Press on/off confirm the setting.
6.4 AirDry
AirDry improves the drying results with
less energy consumption.
While the drying phase
operates, a device opens the
appliance door. The door is
then kept ajar.
flashes and
and are
and are
and
off = Acoustic