Ec Declaration Of Conformity - Proxxon AS/E Manual

Translation of the Original
GB
Operating Instructions
Vacuum cleaner controller AS/E
Operation
The vacuum cleaner controller AS/E is used to control
your floor or workshop vacuum cleaner. To do so, the
working device and vacuum cleaner are connected to
the vacuum cleaner controller which automatically
actives the vacuum cleaner when the working device
is switched on. Vacuuming only occurs when the
working device runs. A follow-up time of approx. 3
seconds ensures a „clean" table after switching off the
working device. An additional switching operation
makes it possible to set the vacuum cleaner to
continuous „on" or continuous „off".
Technical data
Voltage:
Input:
Output:
Power output:
for tool:
for vacuum cleaner:
Commissioning
1. Connect the mains cable of the vacuum cleaner
controller AS/E to the mains (red LED will indicate
operational readiness)
2. Switch off the power tool and vacuum cleaner
3. Connect the power tool to the socket outlet for the
tool
4. Connect the vacuum cleaner to the socket outlet for
the vacuum cleaner
5. Set the required switch position:
„I" = AUTO
This position activates the vacuum cleaner as soon as
the connected power tool is switched on. The AS/E
only responds if the connected power tool has a
minimum output of 25 watt. When the power tool is
switched off, the vacuum cleaner also switches off
after a follow-up time of approx. 3 seconds.
„0" = OFF
The vacuum cleaner remains switched off in this
position.
230 Volt 50-60 Hz ~
230 Volt, 50-60 Hz ~
max. 500 Watt
max. 1500 Watt
„II"= ON
This position activates the vacuum cleaner
immediately, independently of whether a power tool is
connected or not.
Attention:
Only vacuum cleaners may be connected to the
vacuum cleaner side! If not in use, disconnect the
mains plug of the AS/E!
The maximum rated input of the power tool is 500
watt; the maximum capacity of the vacuum cleaner is
1500 watt. Otherwise, the AS/E could be destroyed.

EC Declaration of Conformity

Name and address
of the manufacturer:
Product designation:
Article No.:
In sole responsibility, we declare that this product
conforms to the following directives and normative
documents:
EU Low Voltage Directive
EU EMC Directive
Date: 25 June 2009
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
Note:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Vacuum cleaner
controller AS/E
27032
2006/95/EC
2004/108/EC
- 3 -