Table of Contents
Advertisement
Quick Links
AVT Ninja 250 Fender
Eliminator Install Guide
1)Remove the lower seat cover on each side of
the bike. First remove the Philips screw and
then carefully full on to cover at each corner to
get it to pop out.
2)Remove the seat by unscrewing the two 5mm
hex bolts(one on each side). Lift the seat out of
place.
3) Remove the rear seat with your motorcycle
key.
4) Removeboth the rear fairings. You will need
to remove: sixtotal 4mm hex bolt from both the
rear fairings.
5) Reach your hand into the fairing as pictured
and start to pop it out of place. Even steady
pressure works best. Lift the fairings out of the
way.
Advertisement
Table of Contents
Related Manuals for AVT Ninja 250 Fender Eliminator
Summary of Contents for AVT Ninja 250 Fender Eliminator
- Page 1 AVT Ninja 250 Fender rear fairings. Eliminator Install Guide 1)Remove the lower seat cover on each side of the bike. First remove the Philips screw and then carefully full on to cover at each corner to get it to pop out.
- Page 2 8) Remove Top Light cover by pulling up on it(its 6)Replace the standard relay with the upgrade secured with Velcro) and lower the OEM fender LED relay: Unplug the OEM relay and pull up to out of the way. *please note how the wires are remove it.
- Page 3 metal insert out of the rubber portion. Do not reuse the metal portion of the inserts)that you 12) Connect the electric connectors: removed in the previous step. Note that you do 1)rectangular white tail light harness(with 3 add the supplied plastic bracket to the bottom wires) 2) white rectangular plug to black of the assembly.
- Page 4 14)Reinstall the rest of the components in reverse order: 1) rear fairings 2)rear and front seats 3) lower seat covers Congratulations on successfully installing your New Ninja 250 AVT Fender Eliminator! Thank you for your order, AVT. www.avt-innovations.com...
Need help?
Do you have a question about the Ninja 250 Fender Eliminator and is the answer not in the manual?
Questions and answers