Graph Of Electrical Installation; Special Safety Rules For Wood Lathe; Electrical Information - Ferax FTS 900 Manual

GRAPH OF ElEcTRIcAl INSTAllATION

III. SPEcIAl SAFETY OF THE WOOD
lATHE
WARNING!Do not operate your wood lathe until it is completely
assembled and installed according to the instructions.
1. For your own safety, read the entire instruction manual before
operating the lathe.
2. Always wear eye protection.
3. Do not wear gloves, necktie, or loose clothing.
4. Tighten all locks before operating.
5. Do not mount a split workplace.
6. Use the lowest speed when starting a new workpiece.
7. Read the warning label attached to the wood lathe.
8. When turning a workpiece, always rough the wood to round
form please stop wood lathe at slow speed. If the lathe is run
so fast that it vibrates, there is a risk that the work place will
be thrown or the tool jerked from your hands.
9. Always rotate the workplace by hand before turning on the
lathe. If the workpiece strikes the tool rest, it could split and be
thrown out of the lathe.
10. Do not allow the turning tools to bite into the wood. The wood
could split or be thrown from the lathe.
11. Always position the tool rest above the centerline of the lathe
when sharping a piece of stock.
12. Do not operate the lathe if it is rotating in the wrong direction.
The workpiece must always be rotating toward you.
13. Before attaching a workpiece to the faceplate, always rough it
out to make it as round as possible, this minimizes the vibra-
tions while the piece is being turned. Always fasten the work-
piece securely to the faceplate, failure to do this could resulet
in the workpiece being thrown away from the lathe.
14. Position your hands so that they will not slip onto the work-
piece.
15. Remove all branches from the workpiece before it is clamped
between the spike or the faceplate.
16. Do not leave the work area before the lathe motor has com-
pletely stopped.
17. Hang the turnings grades on the wall behind and beside mot-
blocket. Do not place them on the workbench so that you have
to go over your rotary lathe substance to achieve them..
18. Keep turning steels with safe and solid grip. Take special care
/ attention when forming a turning blank of knots or voids.
19. Always put safety first.
Blue
Switch
COW
Brown
Blue
Green and yellow
Maskinkropp
20. Sand always ready lathe ingredients by hand before being
IV. ElEcTRIcAl INFORmATION
GUIDElINES FOR USING EXTENSION cORDS
WARNING! THIS WOOD LATHE IS FOR INDOOR USE
ONLY. DO NOT EXPOSE TO RAIN OR USE IN DAMP
LOCATIONS.
Make sure your extension cord is in good condition. When using
an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and overheating. The
table below shows the correct size to use according to cord length
and nameplate ampere rating. If in doubt, use the next heavier
gauge. The samller the gauge number, the heavier the cord.
Extension lead sizes shown assure a voltage drop of not more
than 5% at rated load of tool.
WARNING! THIS TOOL MUST BE GROUNDED WHILE IN
USE TO PROTECT THE OPERATOR FROM ELECTRICAL
SHOCK.
46
Motor
Secondary Winding
Main winding
Hood
removed from the lathe.
White
Red