Triton AJA150 Operating And Safety Instructions Manual

Overhead mounting kit

Advertisement

Overhead
Mounting Kit
AJA150
Operating and
Safety Instructions
www.tritontools.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AJA150 and is the answer not in the manual?

Questions and answers

Summary of Contents for Triton AJA150

  • Page 1 Overhead Mounting Kit AJA150 Operating and Safety Instructions www.tritontools.com...
  • Page 2: Symbols

    Please read this manual to make sure you get the full benefit of this unique Triton product. Keep this manual close to hand and ensure all users of this tool have read and fully understand the instructions.
  • Page 3: Parts List

    PARTS LIST A. Mounting plate (1) B. Alignment disc (1) C. Adaptor ring (1) D. Adaptor ring (1) F. Coach bolts (4) E. Router locators (4) G. Spring washers (8) H. Hex nuts (4) I. Top clamps (4) J. Wing nuts (4) K.
  • Page 4: Safety

    SAFETY INSTRUCTIONS WARNING. Read all safety warnings 3. Personal safety and all instructions. Failure to follow the Do not use a power tool while you are tired warnings and instructions may result in or under the influence of drugs, alcohol or electric shock, fire and/or serious injury.
  • Page 5 d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. e. Always unplug your power tool when leaving it unattended.
  • Page 6: Setting Up

    SETTING UP Fitting your router If the router has a square or rectangular base you may need to reposition one or more of the The alignment disc (B) provides easy and locators until you have found four clear positions accurate positioning of the router on the for fitting the top clamps.
  • Page 7 Only use the jigsaw upside down in conjunction Always do a dummy run after each new set-up. with the Triton Router and Jigsaw Table. Remove the workpiece, keep the power switched off and make sure the cutter won't hit anything Warning.

Table of Contents