Start Up En - Flex VCE 45 M AC Original Instructions Manual

Start up
The appliance allows 2 operating modes:
1 Industry vacuum cleaner mode (socket
not used)
2 Dedusting mode (socket used)
 Connect the suction hose and insert in-
sert the suction nozzle or connect to the
dust-generating device depending on
the operating mode.
Warning
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
Horn
The horn blows when the air speed falls be-
low 20 m/s.
Note: The horn reacts to negative pressure.
 Set the rotary switch to the correct suc-
tion hose cross-section.
Anti-static system
Static charge is deflected by providing earth-
ing to the connection nozzles. This prevents
the formation of sparks and current shocks
due to attachments (option) with electrical
conductivity.
Dry vacuum cleaning
The appliance is fitted with a paper filter
–
bag with locking slide, order no.
340.758.0 (5 pcs).
The appliance is equipped with a dis-
–
posal bag with locking slide and locking
strip, order no. 340.766 (10 pc).
Note:You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note:The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 0.1 mg/m .
3
EN
Warning
The flat pleated filter must must always be
in place while vacuuming.
To suck fine dust, you can also use an
–
additional paper filter bag or disposal
bag.
Inserting the paper filter bag
Illustration
 Release and remove the suction head.
 Insert the paper filter bag.
 Insert and lock the suction head.
Installing the dust disposal bag
Illustration
Note: The opening of the disposal bag
must be pulled all the way over the ledge of
the suction support.
 Release and remove the suction head.
 Attach disposal bag.
 Pull disposal bag over the container.
 Insert and lock the suction head.
Wet vacuum cleaning
Danger
No dusts hazardous to health should be
sucked in during wet vacuuming.
Close the suction connection
Illustration
 Properly insert the connection socket in
the suction connection.
 Push in the connection socket until it
locks into place.
 Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".
Remove the paper filter bag
Illustration
 Release and remove the suction head.
 Pull the paper filter bag out towards the
rear.
 Pull the locking slide up and seal the pa-
per filter bag tightly when removing it.
 Dispose off the used paper filter bag in
a dust-tight bag according to the statu-
tory provisions.
 Insert and lock the suction head.
To suck wet dirt, first remove the paper
–
filter bag.
3
-
17