Advertisement
TM
6
7L
10
8
Remove all the parts from carton, separate them into part numbers indicated
on the list and make sure part quantities are correct.
STEP 1 Insert five Casters (2) into Base (1), push hard until you hear or feel Caster (2) snap into place. Insert Pneumatic Cylinder (3) into Base (1).
STEP 2 Attach Arms (7L & 7R) to Seat Cushion (5) using one Arm Knob w/ Washer (8) for each Arm (7). FULLY TIGHTEN ARM KNOBS w/ WASHER (8).
STEP 3 Attach Mechanism (4) to Seat Cushion (5) using four Mechanism Screws (9). FULLY TIGHTEN ALL MECHANISM SCREWS (9).
STEP 4 Attach Back Support (11) to rear of Mechanism (4) using three Back Support Screws w/ Washers (10). FULLY TIGHTEN BACK
SUPPORT SCREWS w/ WASHERS (10).
STEP 5 Place the assembled seat on top of Pneumatic Cylinder (3) and apply pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
24/7 HIGH INTENSITY USE CHAIR
ASSEMBLY INSTRUCTIONS
5
11
4
9
3
1
2
54666
7R
8
PART
1. Base . . . . . . . . . . . . . . . . . . . . . . . 1
2. Caster . . . . . . . . . . . . . . . . . . . . . . 5
3. Pneumatic Cylinder . . . . . . . . . . . . 1
4. Mechanism . . . . . . . . . . . . . . . . . . 1
5. Seat Cushion . . . . . . . . . . . . . . . . . 1
6. Back Cushion . . . . . . . . . . . . . . . . 1
7. Arms (7L & 7R) . . . . . . . . . . . . . . . 2
8. Arm Knob w/ Washer . . . . . . . . . . . 2
9. Mechanism Screw . . . . . . . . . . . . . 4
10. Back Support Screw w/ Washer . 3
11. Back Support (pre-installed) . . . . 1
12. Allen Wrench . . . . . . . . . . . . . . . . 1
QTY
© Office Star Products August 2011
Advertisement
