Advertisement
Plug the mains lead into a 13 Amp mains socket.
If connecting via an extension lead, make sure that the lead is rated at 10
Amps or more, and that it is fully unwound.
Switch the unit on at the mains socket.
Turn the rotary switch to select the required operation:
0 = Off.
Fan symbol = cool air
1 = Low Heat
2 = High Heat
Do not touch the air output grille when the heater is in operation, because it
will be hot and may cause burns.
Unplug the heater from the mains when not in use.
The thermostat can be use to regulate the room temperature.
Turn the switch to the "hot air" position, and rotate the temperature control
fully clockwise.
The heater will then operate at maximum output. When the desired
temperature is reached, rotate the temperature control anticlockwise until a
click is heard. The heater will then switch on and off to keep the room at the
desired temperature. The indicator light will show that this is happening.
Either the "Warm air" or the "hot air" setting can be used.
If the temperature control is rotated fully anticlockwise, it will operate as a
"frost-stat" and switch the heater on if the temperature drops below 4° C,
preventing damage by frost.
OPERATION
Using the Thermostat
Advertisement
