Bandit 240 DB Service & Maintenance Procedures Manual

Security fogging unit

Hide thumbs Also See for 240 DB:

Download this manual

SERVICE & MAINTENANCE PROCEDURES

The BANDIT 240 DB range of security fogging systems are specifically designed to provide high reliability and

simple, quick and minimal maintenance requirements. The Control Box installed with each BANDIT is a

device which allows all main test activities to be carried out from a single location, remote from the BANDIT.

These are the functions of the item:

Disable fog ejection

Red light illuminates when

The FOG BANDIT Recommended service schedule

Non- Warranty requirement (Optional)

Recommended ANNUALY if opportunity arises i.e. if already on site servicing intruder alarm. (estimated

time required 15 – 20 minutes)

 Carry out a 1 second test fog ejection, by operating the appropriate button on the Control Box.

 Ensure there is sufficient remaining fluid in the HY-3 Cylinder Pack, by viewing the real-time LED

indication, shown on the Control Box. If the level indicates less than ~25%, or it is in the red sector,

the HY-3 Cylinder Pack should be replaced at the earliest opportunity in order to ensure maximum

operational capacity.

 If the front cover appears to be very dusty then gently brush or vacuum the textile of the BANDIT to

ensure adequate air circulation is maintained.

 Check all cable runs (particularly if rodents are believed to be present) including those to any

peripheral devices connected directly to the Bandit i.e. dedicated PIR's, PA buttons and Warning

Announcers.

FOR THE BANDIT 240 DB SECURITY FOGGING UNIT

Inhibit tamper protection

of HY-3 side hatch

Green light illuminates

when ON

Routine service consists of the procedures listed below.

Activate 1 second fog

ejection test

HY-3 fluid level

read out

(graduated LED scale)

Activate "OK Technical

Out" (fault) output signal

Page 1 HY-3 Cylinder Pack should be replaced at the earliest opportunity in order to ensure maximum operational capacity.  If the front cover appears to be very dusty then gently brush or vacuum the textile of the BANDIT to ensure adequate air circulation is maintained.
Page 2 HOW TO REPLACE THE HY-3 FLUID CYLINDER FOR A BANDIT 240 DB SECURITY FOGGING UNIT POINTS TO NOTE BEFORE YOU START:  As long as your Fog Bandit is not ‘set’ (i.e., ‘Guard’ light on the front is not on) the HY-3 Fluid Cylinder can be replaced without the possibility of a fog ejection.
Page 3  Whilst still ‘set’, then ‘activate’ the Bandit by the normal means (moving in front of an intruder detector, sensor, etc.) – confirm that the red ‘Alarm’ light also illuminates on the front of the Bandit, which indicates it has successfully ‘activated’...