Advertisement
5
Solid
5
Stranded with end sleeve
Front panel key functions
Note:
1. In Configuration mode,
2. Set-Point High will only accept values greater than Set-Point Low. Also, both values should be Integer.
2
7UG0583 - 1CU20
0.5 Nm
1 x (0.75 to 2.5) mm
2
2 x 0.5 to 2 x 1.5 mm
2
1 x (0.5 to 2.5) mm
2
2 x (0.5 to 1.5) mm
2
Both the relays will turn OFF.
From Page 1.
* By default, Sensor type will be considered as PNP.
In case of NPN sensor type, NPN-COM to be shorted.
** For three wire sensor, connect the sensor to internal +12V as shown
or use external supply (5 to 30V) if required.
Note: If the sensors require more than 30mA current, use external power
supply to power the sensors. To reduce noise, Use of Snubber across load
is recommended.
Advertisement
