Advertisement

Quick Links

MANUAL:
SHINOLA BLUETOOTH
IN-EAR MONITORS

Advertisement

Table of Contents
loading

Summary of Contents for SHINOLA BLUETOOTH IN-EAR MONITORS

  • Page 1 MANUAL: SHINOLA BLUETOOTH IN-EAR MONITORS...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS TECHNICAL SPECIFICATIONS DECLARATION NOTICE FULL BUTTON INTERFACE DECLARATION OF CONFORMITY PAIRING YOUR DEVICE BATTERY SAFETY FOR THE FIRST TIME DISPOSAL OPERATION COMPLIANCE WITH FCC RULES CHARGING WARNING ERASE PAIRED DEVICE LIST NOTE INTENDED USE AVOID HEARING DAMAGE...
  • Page 3: Technical Specifications

    TECHNICAL SPECIFICATIONS TRANSDUCER TYPE: 8.5 MM FREQUENCY RESPONSE: 10H Z - 20KH Z TOTAL HARMONIC DISTORTION: < 1% IMPEDANCE: 16.5 Ω @ 1KHZ SOUND PRESSURE LEVEL: 102 DB...
  • Page 4 TECHNICAL SPECIFICATIONS BLUETOOTH: Bluetooth® 4.2 with AAC, AptX and AptX-HD Support PLAYBACK: 12 Hours Of Music Playing Time CHARGING: Fast Charging via USB-C (USB-A to USB-C Cable Included)
  • Page 5: Full Button Interface

    FULL BUTTON INTERFACE MULTI-FUNCTION (MF) VOLUME DOWN VOLUME UP USB CHARGING...
  • Page 6 FULL BUTTON INTERFACE 1X AN SWE R / HANG U P PR E SS AN D HOLD TO R EJ ECT 1X PLAY/ PAUS E 2X S KI P FORWAR D 3X S KI P BACKWAR D PR E SS AN D HOLD FOR ON /OFF PR E SS AN D HOLD FOR 4-5 S ECON DS TO PAI R /OFF VOLU M E U P:...
  • Page 7: Pairing Your Device For The First Time

    If the LED quickly flashes orange, the battery is low. 2. Go to the “Bluetooth Devices” list on the music source and select “Shinola Bluetooth IEM.” Listen for the audible tone to ensure the music source has successfully paired with the tether.
  • Page 8 PAIRING YOUR DEVICE FOR THE FIRST TIME TURN BLUETOOTH IEM ON 1. Press and hold the MF button until the LED turns white, then continue holding for 2 seconds. If the LED turns orange, the battery is low. NOTE: the tether will pair to a recently connected device if Bluetooth®...
  • Page 9: Operation

    OPERATION 1. Find the “L” and “R” markers on the ends of the In-Ear Monitor cable. 2. Select the right sized eartips for your ears, as a proper seal is critical to ensure a quality listening experience. Choose from the included selection of memory foam and silicone eartips.
  • Page 10: Charging

    OPERATION 3. To ensure safe listening levels, do not place In-Ear Monitors in your ears until after they are producing sound. CHARGING 1. The LED will flash orange when the battery is low. To charge the tether, plug the charging cable into the USB-C charging port and then attach the other end to a power source.
  • Page 11: Erase Paired Device List

    LED flashes white four times. INTENDED USE Office and Home Usage Shinola Detroit, LLC accepts no liability whatsoever for any damage to this product or injuries caused due to careless, improper or incorrect use of the product or use of the product...
  • Page 12: Avoid Hearing Damage

    AVOID HEARING DAMAGE PLEASE NOTE: Listening to audio for extended periods at loud volume levels may cause permanent hearing damage, so check the volume level that has been set on the volume control each time before using the product, and avoid listening to audio at a high volume level.
  • Page 13: Declaration Of Conformity

    DECLARATION OF CONFORMITY Shinola Detroit, LLC herby declares that this product conforms to the relevant safety regulations of EU Directive 2014/53/EU. BATTERY SAFETY This product is fitted with a lithium polymer battery. Do not damage, open or dismantle the battery and do not use it in damp and/or corrosive conditions.
  • Page 14: Disposal

    DISPOSAL The crossed-out wheelie-bin symbol means that you may not dispose of this product together with general household waste; instead, take it to a recycling point for electrical and electronic equipment. For information about local recycling points, contact your local authority, civic amenity site or the business where you purchased this product.
  • Page 15: Compliance With Fcc Rules

    COMPLIANCE WITH FCC RULES This device complies with Part 15 for the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Page 16: Note

    NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

Table of Contents