TracStar SV360 Setup

Setting up your dish network receiver and tracstar antenna to receive satellites 110/119/129

Hide thumbs Also See for SV360:

Setting u p y our D ish N etwork r eceiver a nd T racStar a ntenna

Before c onfiguring y our s ystem t o w ork w ith d ishwork i t m ust m eet t he m inimum

requirements.

First t urn o n y our s ystem o r P ower c ycle i t y ou s hould s ee o n t he d isplay " POWER U P

PLEASE W AIT" n ext y ou s hould s ee " IDB2 V er x .x" t his m ust b e h igher t han 3 .1

Next H it t he m enu b utton o ne t ime t o s ee t his s oftware " Ver x .xxG" G i s t he r equirement

The S V 3 60 m ust b e a d ual s ystem.

If t he 1 10 a dapters a re i nstalled t hey m ust b e r emoved.

It i s r ecommended t hat y ou u se a d ish n etwork 3 11 o r 2 11 r eceiver.

If y ou p lan o n u sing 2 r eceivers m ore t han l ikely y ou're " NAS d estacker" w ill n eed t o b e

modified.

Important: Your TracStar antenna must have an unobstructed view of the

southern sky to be able to locate satellites 110, 119 and 129.

1. Set the Tracstar antenna to satellite 119 only ("arrow" button one

time then + or – until IDD reads sat 119, then press the "enter"

button). Wait for the antenna to lock on to 119.

RV S atellite S ystems

(714) 6 30-‐7276

to r eceive s atellites 1 10/119/129.

Table of Contents

Need help?

Do you have a question about the SV360 and is the answer not in the manual?

Page 1 Important: Your TracStar antenna must have an unobstructed view of the southern sky to be able to locate satellites 110, 119 and 129. 1. Set the Tracstar antenna to satellite 119 only (“arrow” button one time then + or – until IDD reads sat 119, then press the “enter”...
Page 2 (do not run the check switch at this time). 4. On your TracStar display press the MAIN button two times until it reads “dealer setup-code 0”. Press the + button until the IDD reads “code 13”, and then press enter.