Advertisement
D
E
F
G
H
I
Display-:
A:
REAL TIME TORQUE VALUE
B:
THE UNIT OF ANGLE
C:
TORQUE UNITS
D:
TARGET TORQUE INDICATOR
E:
TARGET ANGLE INDICATOR
F:
MEMORY STORAGE NUMBERS
G:
BATTERY INDICATOR
H:
PEAK / TRACK MODE
I :
MINUS SYMBOL A.C.W. ROTATION
NEW USER NOTES:
Familiarise yourself with the display and control panel.
Practice setting up by holding the torque wrench 1/2"
drive in a vice. Set units, torque, angle figures and
test for visual, audible, vibration signals by sweeping
the torque arm..
INITIAL OPERATION:
4.2
Power On.
4.2.1 Place the wrench on a horizontal level surface
and press the
wrench.
4.2.2 Press the
button again to turn the
wrench off.
SET-UP
4.3
Track Mode: After turning on the torque
wrench it will be set in 'track' mode.
This means once the torque is reached and
pressure is taken off the torque wrench the
display rolls back down to ZERO.
4.4
Peak Hold Mode: Use the wrench in exactly
the same way, except that when the force is
released, the display stays at the maximum
torque that has been applied.
After two seconds the display will flash. Either
continue on the next operation or press the
button to ZERO the value and continue onto
the next operation.
4.5
Track and Peak Mode Setting.
4.5.1 Press the
button to turn the wrench on.
4.5.2 Cycle the
button to select peak or track.
Press
to confirm.
© Jack Sealey Limited
The Wrench
A
B C
button to turn on the torque
Original Language Version
1
4
Control panel-:
1:
POWER ON/OFF
2:
MEMORY PRE-SETS/SETTING
SELECTION
3:
MEMORIZE TORQUE or ANGLE
CHANGE ROTATION
4:
ZERO TORQUE/ANGLE
5:
*BACK LIGHT/NEXT DIGIT SELECT/
ENTER ANGLE MODE
* Hold down for 3 seconds "on" / 2 seconds "off".
Note: If no buttons are pressed within 10
seconds the display will return to the main
screen.
4.6
Unit Selection.
4.6.1 Press the
4.6.2 When the peak or track mode has been
confirmed the wrench will go to unit selection.
Nm
lbf.ft
lbf.in
kgf.m
4.6.3 Nm will be shown, Press the
scroll through different measurements.
4.6.4 Press the
button to confirm.
If no buttons are pressed within 3 seconds
the display will return to the main screen.
4.6.5 After confirming, the screen will automatically
move onto the next setting (Auto Power Off).
4.7
Auto Power Off
4.7.1 When the unit selection has been confirmed
the wrench will go to Auto Power Off setting.
4.7.2 On the auto power off screen the default time
will be shown (5 minutes).
4.7.3 Press the
button to scroll through the
settings.
5 Minute
15 Minutes
4.7.4 To confirm, press the
If no buttons are pressed within 3 seconds
the display will return to the main screen.
4.7.5 After confirmation, the screen will return to the
main screen.
button for 3 seconds
button to
No Auto
Power Off
button.
STW306.V2 Issue: 2(I) - 13/06/16
2
3
5
Advertisement
