Whirlpool MW87OOXL Use And Care Manual page 4

Using your microwave oven
MICROWWE OVEN CONTROLS
There are three ports In the control section:
-The Digital Display Clock,
- Command
Pods and Signal Lights,
- Number Pods.
What each of these does will be covered
on the following pages. Read them carefully.
When you first plug in the oven, the Display
will show 88:88. If, after you set the Clock
a
Con&l Panel ON /OFF Switch
(page 5), the Display again shows @II 8's it
means your electricity 'was off for a while
Reset the Clock.
One note: The Command and Number
Pads are not buttons. You don't have to
Dush them...iust touch them.
DIGITAL DISPLAY /CLOCK
~-
When you are using the micr6wave oven,
this acts OS a display. It counts down time
settings and it shows you what number pods
you touched.
COMMAND PADS AND SIGNAL LIGHTS
Touch Com-
mand Pods to tell
the microwave
oven what to do
and in what order.
A few examples:
-COOK CYCLE 1
cook at less than full power.
- START tells the oven to start.
Each Command Pod has its own Signal
Light (except START and CANCEL). The Signal
Light comes on when you touch the Com-
mand Pod.
While the oven is running, o Signal Light [or
lights] will be on to show what the oven is
doing.
NUMBER PADS