The wall or ceiling structure must be capable of supporting at least five (5) times the weight of projector. If not, the wall or ceiling must be reinforced.
Proper installation procedure by qualified personnel as outlined in the installations instructions must be adhered to. Failure to do so could result in
Step 1
Remove the middle extension from the 3M mount by removing two (2) of the M8 x 16 hex head
screws washers and star washers from the top and bottom holding the extension. See figure 1.
Wireless network module for multimedia projector mp8790 (39 pages)
Summary of Contents for 3M HE100
Page 1
Step 1 Remove the middle extension from the 3M mount by removing two (2) of the M8 x 16 hex head screws washers and star washers from the top and bottom holding the extension. See figure 1.
Page 2
Step 2 Replace the middle extension with the 78-6969-9698-8 with the same hardware that was removed. Figure 2 CEILING PLATE M8 HEX HEAD SCREW FLAT WASHER STAR WASHER M8 HEX HEAD SCREW FLAT WASHER 78-6969-9698-8 STAR WASHER EXTENSION M8 HEX HEAD SCREW FLAT WASHER STAR WASHER M8 HEX HEAD SCREW...
Page 3
Locate the center of the single wood stud in the ceiling or on the wall. Secure the upper plate to the single stud using the three (3) #14 wood screws (supplied) with the 3M mount or use (commercially available) suitable hardware depending on your installation environment.
Page 4
Step 4 Step 5 Fully raise the safety and tension knobs pick the projector with the mounting bracket For grater height adjustability or changing the remove the projector from the bell attached. Fully insert the arrow design opening from the mounting bracket to the housing, loosen the screws make your height adjustment or choose the lower slot.